EC Line EC-2D Especificações descarregar pdf (Página 152)

145

Chapter 9 Bluetooth Configuration

This!Chapter!is!only!adaptable!for!EC!IGM2DBT.!

SCANNER MODE SELECTION

< SPP Master Mode >

Please follow the steps to setup the communication between the scanner and

cradle.

1) The scanner must scan “SPP Master Mode” barcode to set the scanner in

master mode.

2) Scan the Bluetooth MAC address code located on the bottom of the cradle.

3) When the Bluetooth MAC address code was successfully scanned, scanner

will sound 3 short beeps with green LED flash once.

4) Wait approximately five seconds for completing the connection process with

up-tone.

5) If successful, blue LED of scanner will slow flash and the cradle will be

continued on.

SPP Slave Mode

Please follow the below steps to setup the communication between the scanner

and Bluetooth application device.

1) The scanner must scan “SPP Slave Mode” barcode, to set the scanner in

slave mode.

2) When control the Bluetooth device to search the scanner, enter pin code

(default 00:00:00) to setup comport.

3) When scanner is successful connected, the scanner blue LED will also blink

with up-tone. Blue LED will slowly flash to finish the setup.

! !

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 191 192

Sem comentários

EC Line EC-2D Especificações Página 152